https://guitarnoise.forum/live-sound/different-ohm-loads-on-chan1-and-chan2/ Guitar Noise Discussion Board en-US Thu, 04 Jun 2026 05:31:28 +0000 wpForo 60 https://guitarnoise.forum/live-sound/different-ohm-loads-on-chan1-and-chan2/#post-314477 Sun, 23 Nov 2008 00:09:42 +0000 So I was also wondering if I could put 1 Cab and 1 Sub on channel 1 and the other cab on channel 2 by itself. I understand that channel 1 would then be 4ohms and "louder" than channel 2, but that is not a concern.
Channel 1 will really not be much louder, because the 2 speakers (full-range & sub) will split the wattage. So I doubt you will really hear a difference between your two full-range speakers.

And as was said, it doesn't really do anything to run a different ohms load on each channel of your amp. Those channels are two completely seperate units from each other, they run independently of each other except when you operate in "bridged" mode.

And welcome to Guitar Noise. :D]]> Live Sound Wes Inman https://guitarnoise.forum/live-sound/different-ohm-loads-on-chan1-and-chan2/#post-314477 https://guitarnoise.forum/live-sound/different-ohm-loads-on-chan1-and-chan2/#post-314472 Sat, 22 Nov 2008 21:10:39 +0000 Live Sound Diceman https://guitarnoise.forum/live-sound/different-ohm-loads-on-chan1-and-chan2/#post-314472 https://guitarnoise.forum/live-sound/different-ohm-loads-on-chan1-and-chan2/#post-34097 Fri, 21 Nov 2008 05:11:43 +0000
Help me out. Thanks
Ryan]]> Live Sound rpmad https://guitarnoise.forum/live-sound/different-ohm-loads-on-chan1-and-chan2/#post-34097